Toyota RAV4 manuals

Toyota Sienna Service Manual: Tire and wheel

Installation
1. INSTALL REAR AXLE BEAM DAMPER (a) Install the rear axle beam damper to the rear axle beam assembly. 2. INSTALL REAR AXLE CARRIER BUSH LH (a) Align the matchmarks on the axle beam assembly ...

Tire and wheel system
...

Other materials:

Open in Curtain Shield Squib LH Circuit
DTC B1166/88 Open in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1166/88 is recorde ...

Terminals of ECU
1. FOLD SEAT CONTROL ECU LH Disconnect the fold seat control ECU connectors. Measure the voltage and resistance of the wire harness side connectors. If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnect the fold seat control E ...

Removal
1. REMOVE REAR WHEEL 2. REMOVE SKID CONTROL SENSOR WIRE (for 2WD) (a) Disconnect the skid control sensor connector. (b) Remove the bolt and disconnect the bracket from the rear axle beam assembly. HINT: Separate the RH side by the same procedures as the LH side. 3. SEPARATE SPEED SENSO ...

В© 2011-2024 Copyright www.tsienna.net