Toyota Sienna Service Manual: Tire pressure warning receiver (w/ antenna)

TC and CG Terminal Circuit

DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by blinks of the tire pressure warning light. WIRING DIAGRAM HINT: When eac ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE ROOF HEADLINING ASSEMBLY HINT: Refer to the instructions for REMOVAL of the ROOF HEADLINING (See page IR-6). 3. REMOVE TIRE PRESSURE ...

Other materials:

Power Window can be Operated After Ignition Switch is Turned OFF Even if Operative Conditions are not Met
DESCRIPTION The multiplex network body ECU controls power supplied to the power window master switch and each regulator switch continuously for 45 seconds after the ignition switch is turned OFF unless the front doors have been opened, so that the power window can be operated during this peri ...

For manual air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT AIR INLET CONTROL SERVO MOTOR (a) Remove the air inlet control servo motor. (b) Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, then check that the lever turns to "RECIRCULATION" side smoothly. ...

Distance Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Distance Control ECU Communication Stop Mode Distance control" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Distance ...