Toyota RAV4 manuals

Toyota Sienna Service Manual: Tire pressure warning system

Toyota Sienna Service Manual / Tire and wheel / Tire pressure warning system

Repair
1. INTRODUCTION (a) This section introduces ways to determine whether the run-flat tire is repairable or not. Repair must be performed by following the appropriate procedures. If a flat tire occ ...

Precaution
1. TIRE PRESSURE WARNING SYSTEM PRECAUTION (a) When the tire pressure warning light comes on, immediately check the tire pressure of the tire and adjust it to the specified value. (The tire pre ...

Other materials:

Cursor or Map Rotates when Vehicle Stopped
INSPECTION PROCEDURE 1 CHECK CONDITION Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by turntable. HINT: If the vehicle is turned on a turntable with the ignition switch on, the system may store the angular velocity. As a ...

Installation
1. INSTALL TRANSFER CASE OIL SEAL (a) Using SST, install anew transfer case oil seal to the transfer case at the position shown in the illustration. SST 09387-00010, 09950-70010 (09951-07150) NOTICE: Do not install it obliquely. (b) Apply small amount of MP grease to the oil seal lip. 2. ...

ECU Power Source Circuit
DESCRIPTION The position control ECU and switch assembly (power seat control switch and ECU) is contained in the switch assembly. During manual operation, only one switch signal is accepted. If signals are input from 2 or more switches simultaneously, all of them are ignored, except when s ...

В© 2011-2026 Copyright www.tsienna.net