Toyota Sienna Service Manual: Transfer assembly

Installation

1. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL (a) Using SST, install a new transfer RH bearing retainer oil seal to the transfer case at the position as show in the illustration. SST 09223- ...

Removal

1. REMOVE ENGINE AND TRANSAXLE HINT: (See page EM-26) 2. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER HINT: (See page AX-164) 3. REMOVE NO. 1 TRANSFER CASE PLUG (a) Remove the No. 1 transfe ...

Other materials:

Crankshaft Position Sensor "A" Circuit
DTC P0335 Crankshaft Position Sensor "A" Circuit DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent DESCRIPTION The Crankshaft Position (CKP) sensor system consists of a CKP sensor plate and a pickup coil. The sensor plate has 34 teeth and is installed on the cra ...

Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU Disconnect the G4 ECU connector. Measure the voltage between the specified terminals on the wire harness side connector. If the result is not as specified, there may be a malfunction on the wire harness side. Measure the resistance between ...

Open in Stop Light Switch Circuit
DTC C1249/49 Open in Stop Light Switch Circuit DESCRIPTION WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK STOP LIGHT SWITCH OPERATION (a) Check that the stop light comes on when the brake pedal is depressed and goes off when the brake pedal is released. OK HINT: Check the stop li ...