ON-VEHICLE INSPECTION
1. INSPECT TRANSFER OIL
(a) Remove the No. 1 plug and gasket.
(b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug.
NOTICE:
(c) When the oil level is too low, check for oil leakage.
(d) Tighten the No. 1 plug with a new gasket.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
2. ADD TRANSFER OIL
(a) Remove the No. 1 plug and gasket and supply oil.
NOTICE:
HINT: The oil level should be within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for the No. 1 plug.
(b) After leaving it alone for 5 minutes, recheck the oil level.
(c) Tighten the No. 5 plug with a new gasket.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
Back Door Courtesy Switch Circuit
DESCRIPTION
The fold seat control ECU receives signals from the back door courtesy switch
and detects the state of the
back door (open/close). If the ECU does not detect that the back door is open,
the seat stowing and return
functions are not available.
WIRING DIAGRAM
INSPECTION PROCED ...
Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
Refer to the instructions for reassembly of the front seat assembly
(for flat type).
Refer to the instructions for reassembly of the front seat assembly
(for manual seat).
Refer to the instructions for reassembly of the ...
ON / OFF Indication Parameter Error
DTC 01-E2 ON / OFF Indication Parameter Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
01-E2
The signal for ON/OFF control from the master device
has a problem
Radio and navigation assembly
INSPECTION PROCEDURE
HINT:
After the insp ...