Toyota RAV4 manuals

Toyota Sienna Service Manual: Transfer system

PRECAUTION

NOTICE:

1. Before disassembly, clean the transfer assembly of any sand or mud to prevent it from entering inside the transfer during disassembly and assembly.

2. When removing any light alloy part such as a transfer cover, do not pry it off with a tool like a screwdriver, but tap it out with a plastic hammer instead.

3. Always arrange the removed parts properly and protect them from dust.

4. Before installation, clean and dry all parts completely, and then apply hypoid gear oil to each part. Do not use alkaline chemicals when cleaning aluminum, rubber parts, or ring gear set bolts. Also do not use any cleaning oil (ex. white gasoline) to clean the rubber parts such as O-rings and oil seals.

5. Apply hypoid gear oil to any sliding surface or rotating part.

6. Do not directly hold a part in a vise. Make sure to put an aluminum sheet between them.

7. Replace any damaged or deformed snap ring with a new one.

8. If there is a scratch on the contact surface of the case, it may cause oil leakage. Therefore, be careful not to to damage the contact surface when handling it.

9. Before applying a sealant, completely remove any old sealant stuck on the parts and clean with white gasoline.

10.Do not add oil immediately after installing sealed parts. Leave for 1 hour or more 11.Scratches on a contact surface of an oil seal, O-ring or gasket may cause oil leakage. Be careful not to damage the contact surface when handling the seals.

12.When press-fitting an oil seal, be careful not to damage the oil seal lip and around it.

13.When replacing a bearing, replace the inner and outer races as a set.

PROBLEM SYMPTOMS TABLE

Transfer system

Transfer
...

Transfer oil
ON-VEHICLE INSPECTION 1. INSPECT TRANSFER OIL (a) Remove the No. 1 plug and gasket. (b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug. ...

Other materials:

PCS (Pre-Collision System)
When the radar sensor detects possibility of a frontal collision, the pre-collision system such as the brakes and seat belts are automatically engaged to lessen impact as well as vehicle damage. Pre-collision warning When a high possibility of a frontal collision is detected, the pre-colli ...

Open in Driver Side Squib 2nd Step Circuit
DTC B1181/18 Open in Driver Side Squib 2nd Step Circuit DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1181/18 is reco ...

Rear Occupant Classification Sensor RH Circuit Malfunction
DTC B1783 Rear Occupant Classification Sensor RH Circuit Malfunction DESCRIPTION The rear occupant classification sensor RH circuit consists of the occupant classification ECU and the rear occupant classification sensor RH. DTC B1783 is recorded when a malfunction is detected in the rear oc ...

В© 2011-2024 Copyright www.tsienna.net