DTC 01-DC Transmission Error
DESCRIPTION
HINT: *1: This code may be stored if the engine is started, idled for 60 seconds and then started again.
NOTICE:
INSPECTION PROCEDURE
NOTICE: Be sure to read DESCRIPTION before performing the following procedures.
1 CHECK FOR DTC OF OTHER COMPONENTS
Result
HINT: For the list of the components shown by sub-codes, refer to the table in step 2.
2 IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE
Component Table:
HINT:
3 CHECK COMPONENT WHICH HAS STORED THIS CODE
Component Table:
END
4 CLEAR DTC
HINT: If "01-DC" is output for only one component, this may not indicate a malfunction
5 RECHECK DTC
OK: Malfunction disappears.
END
Disassembly
1. REMOVE COOLER THERMISTOR NO.1 (for Automatic Air Conditioning System)
(a) Disengage the 2 claw fittings and the clamp and
remove the cooler thermistor No. 1.
2. REMOVE COOLING UNIT MOTOR SUB-ASSEMBLY WITH FAN
(a) Remove the 3 screws and the cooling unit motor
sub-assembly w/ fan.
3. ...
Mass or Volume Air Flow Circuit Range / Performance Problem
DESCRIPTION
Refer to DTC P0100 (See page ES-116).
MONITOR DESCRIPTION
The MAF meter is a sensor that measures the amount of air flowing through the
throttle valve. The ECM
uses this information to determine the fuel injection time and to provide an
appropriate air-fuel ratio.
Insi ...
Radio Receiver Communication Error
INSPECTION PROCEDURE
1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE
Enter the diagnostic mode
Press the preset switch "3" to change to "Detailed
Information Mode".
Identify the component shown by the sub-code.
HINT:
"190 (radio receiver) ...