Toyota Sienna Service Manual: Transponder Chip Malfunction
DTC B2793 Transponder Chip Malfunction
DESCRIPTION
This DTC is output when a malfunction is found in the key during the key code registration or the key code is not registered normally. Replace the key when the key code registration is not performed normally and this DTC is detected.
INSPECTION PROCEDURE
1 CHECK DTC OUTPUT
- Delete the DTC.
- Insert the key into the ignition key cylinder.
- Check that no code is output.
OK: No DTC is output.
2 RE-REGISTER KEY
- Delete the DTC.
- Re-register the key and insert this key into the ignition key cylinder.
Check that the engine starts with the key.
OK: The engine starts
REPLACE KEY
Antenna Coil Open / Short
DTC B2784 Antenna Coil Open / Short
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and
receives a key code signal from
the transponder chip in the key. This sign ...
Unmatched Encryption Code
DTC B2794 Unmatched Encryption Code
DESCRIPTION
This DTC is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
DTC No.
DTC Detection Condi ...
Other materials:
Power mirror control system (w/o Memory)
PARTS LOCATION
Problem symptoms table
POWER MIRROR CONTROL SYSTEM
Symptom
Suspected area
Mirror does not operate
Outer mirror switch assembly
Outer rear view mirror assembly
Wire harness
Mirror operates abnormally
O ...
Reassembly
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad to the brake pedal subassembly.
2. INSTALL PUSH ROD PIN
(a) Apply lithium soap base glycol grease to inside
surface of 2 new push rod bushes.
(b) Install the 2 new push rod bushes.
(c) Install the 2 push rod pins with the 2 plate t ...
Short to B+ in Side Squib RH Circuit
DTC B0113/42 Short to B+ in Side Squib RH Circuit
DESCRIPTION
The side squib RH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0113/42 is recorded when a sh ...
