Toyota Sienna Service Manual: Turn signal light switch
ON-VEHICLE INSPECTION
1. INSPECT TURN SIGNAL FLASHER CIRCUIT
- Measure voltage between the terminals as shown in the chart below.
Voltage
- Connect the connector to turn the signal flasher and turn the ignition switch ON, and inspect the wire harness side connector from the back side as shown in the chart.
Voltage
Headlight dimmer switch
COMPONENTS
REMOVAL
1. REMOVE STEERING COLUMN LOWER COVER
2. REMOVE STEERING COLUMN UPPER COVER
3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
Disconnect the connector.
Releas ...
Hazard warning switch
INSPECTION
1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Check that there is resistance between the
terminals at each switch position as shown in the
chart.
Resistance
Inspect ...
Other materials:
Past record
Type A
Press the “CAR” button.
Type B
Press the “APPS” button, and then select “Eco” on the screen.
If the “Trip Information” screen is displayed, select “Past Record”.
Reset the past record data
Best recorded fuel consumption
Average fuel consumption ...
Position Sensor Circuit
DESCRIPTION
When SET and 1 or 2 are pressed, the position sensor detects the mirror
position and sends the signal to
the outer mirror control ECU. Then when position 1 or 2 is pressed, the outer
mirror control ECU drives
the mirror motor based on the memorized sensor positions.
HINT:
The ...
Definition of terms
Terms
Definitions
Monitor Description
Description of what ECM monitors and how to detect malfunctions
(monitoring purpose and details).
Related DTCs
A group of diagnostic trouble codes that are output by ECM based on
the same malfunction detection lo ...
