Toyota Sienna Service Manual: Underdrive clutch

Disassembly

1. INSPECT UNDERDRIVE PACK CLEARANCE HINT: (See page AX-262) 2. REMOVE UNDERDRIVE CLUTCH FLANGE NO.2 HOLE SNAP RING a) Using a screwdriver, remove the underdrive clutch flange No.2 snap rin ...

Other materials:

Installation
1. INSTALL STEERING ANGLE SENSOR (a) Install the steering sensor onto the spiral cable. 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See page RS-434) 4. INSTALL STEERING COLUMN COVER LWR (See page RS-435) 5. CENTER SPIRAL CABLE (See page RS-435) 6. IN ...

Panel Switches do not Function
INSPECTION PROCEDURE 1 CHECK PANEL SWITCH Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found 2 CHECK PANEL SWITCH (DISPLAY CHECK MODE) Enter the "Display Check" mode (Panel Switch Check).  Operate the abnorma ...

Installation
1. Install heated oxygen sensor (for bank 2 sensor 2) (see page ec-34) 2. Install front exhaust pipe assembly (a) Install 2 new gaskets to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 4 nuts. Torque: 62 n*m (632 kgf*cm, 46 ft.*Lbf) 3. INSTALL CE ...