Entry function (vehicles with a smart key system)
Carry the electronic key to enable this function.
The doors cannot be unlocked for 3 seconds after the doors are locked.
*: The door unlock settings can be changed.
Check that the door is securely locked.
Wireless remote control
Key
Turning the key unlocks the driver’s side doors. Turning the key again within 3 seconds unlocks the other doors.
The doors can also be locked and unlocked with the mechanical key.
Operation signals
A buzzer sounds and the emergency flashers flash to indicate that the doors have been locked/unlocked. (Locked: Once; Unlocked: Twice)
Security feature
If a door is not opened within approximately 60 seconds after the vehicle is unlocked, the security feature automatically locks the vehicle again.
When the door cannot be locked by the lock sensor on the upper part of the front door handle
Touch both lock sensors on the upper and lower part of the front door handle simultaneously.
Door lock buzzer
If an attempt to lock the doors (except for power sliding doors or power back door) is made when a door is not fully closed, a buzzer sounds continuously.
Fully close the door to stop the buzzer, and lock the vehicle once more.
Alarm (if equipped)
Using the wireless remote control to lock the doors will set the alarm system.
If the smart key system or the wireless remote control does not operate properly
Vehicles with a smart key system: Use the mechanical key to lock and unlock the doors. Replace the key battery with a new one if it is depleted
DTC check / clear
1. CHECK DTC
Connect the intelligent tester to the Controller Area
Network Vehicle Interface Module (CAN VIM). Then
connect the CAN VIM to the DLC3.
Turn the ignition switch on.
Turn the tester ON.
Enter the following menu items: DIAGNOSIS / OBD/
MOBD / IM ...
Random / Multiple Cylinder Misfire Detected/ Cylinder Misfire Detected
DTC P0300 Random / Multiple Cylinder Misfire Detected
DTC P0301 Cylinder 1 Misfire Detected
DTC P0302 Cylinder 2 Misfire Detected
DTC P0303 Cylinder 3 Misfire Detected
DTC P0304 Cylinder 4 Misfire Detected
DTC P0305 Cylinder 5 Misfire Detected
DTC P0306 Cylinder 6 Misfire Detected
DESCRIPTION ...
Operation check
NOTICE:
Inspection should be started after conforming that the
items listed in the "CUSTOMIZE PARAMETER" for the
power slide door system have defaulted to the initial
settings.
1. CHECK OPENING OPERATION
Conditions necessary for the power slide door to
open:
Power slid ...