Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Using the driving support systems

Toyota Sienna 2010-2026 Owners Manual / Driving / Using the driving support systems

Closing the fuel tank cap
After refueling, turn the fuel tank cap until you hear a click. Once the cap is released, it will turn slightly in the opposite direction. WARNINGWhen replacing the fuel tank cap Do ...

Cruise control
...

Other materials:

Hazard warning switch
INSPECTION 1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY  Check that there is resistance between the terminals at each switch position as shown in the chart. Resistance Inspect illumination operation.  Connect the positive (+) lead from the battery to the termina ...

Installation
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH (a) Install the hub & bearing assembly LH with the 4 bolts. Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf) 2. INSPECT BEARING BACKLASH (See page AH-19) 3. INSPECT AXLE HUB DEVIATION (See page AH-19) 4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (Se ...

Clock
PARTS LOCATION On-vehicle inspection 1. INSPECT INTEGRATION CONTROL & PANEL ASSEMBLY  Disconnect the A9 connector.  Measure the voltage according to the value(s) in the table below. Standard voltage Measure the resistance according to the value(s) in the ...

В© 2011-2026 Copyright www.tsienna.net