Radio operation
Select “AM” or “FM” on the audio source selection screen to begin listening to the radio.
Pressing the “AUDIO” button displays the audio control screen from any screens of the selected source.
*: FM only
Tune in to the desired station using one of the following methods.
Seek tuning
Press the “” or “” button on “SEEK•TRACK”.
The radio will begin seeking up or down for a station of the nearest frequency and will stop when a station is found.
Manual tuning
Turn the “TUNE•SCROLL” knob.
Preset stations
Select the desired preset station.
To change the preset station to a different one, select and hold the preset station.
Refreshing the station list
To cancel the refresh, select “Cancel Refresh”.
Reception sensitivity
Diagnostic trouble code chart
1. DTCS FOR AIRBAG SYSTEM
If a malfunction code is displayed during the DTC check,
check the circuit listed for the code in the table below
(Proceed to the page listed for that circuit).
HINT:
When the SRS warning light remains on and the DTC
output is the normal system code, a volta ...
Power back door drive unit
INSPECTION
1. INSPECT POWER BACK DOOR DRIVE UNIT
Remove the unit.
Apply battery voltage to the terminals and check the
motor operation.
Standard
If the result is not as specified, replace the drive
unit.
Check the resistance of the clutch terminals.
Resistance
If th ...
ABS Control System Malfunction
DTC 43 ABS Control System Malfunction
DESCRIPTION
This DTC is output when the VSC system detects a malfunction in the ABS
control system.
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration
(See page BC-70).
1 CHECK ABS CONTROL SYSTEM
( ...