Toyota Sienna Service Manual: Vacuum switching valve

Installation

1. INSTALL CHARCOAL CANISTER ASSEMBLY (a) Install the 3 bolts and charcoal canister. Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) (b) Connect the purge line hose to the charcoal canister. (c) ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE V-BANK COVER SUB-ASSEMBLY (See page EM-28) 3. REMOVE PURGE VSV (a) Disconnect the purge VSV connector. (b) Disconnect the 2 pur ...

Other materials:

Removal
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 4. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY LH 5. REMOVE SEAT MEMORY SWITCH  Disengage the 4 claws and remove the seat memor ...

Adjusting the set speed
To change the set speed, operate the lever until the desired set speed is obtained. Increases the speed Decreases the speed Fine adjustment: Momentarily move the lever in the desired direction. Large adjustment: Hold the lever in the desired direction. The set speed will be incre ...

Inspection
1. INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) (a) Measure the resistance of the sensor. Standard resistance If the resistance is not as specified, replace the sensor. 2. INSPECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) (a) Measure the resistance of the sensor. Standard r ...