Toyota RAV4 manuals

Toyota Sienna Service Manual: Vacuum tank

On-vehicle inspection

1. Inspect air cleaner cap sub-assembly

 Inspect air cleaner cap sub-assembly

(A) check that air flows from port b to port a.

(B) apply 60 kpa (450 mm hg, 18 in. Hg) of vacuum to port b. Check that there is no change of vacuum after one minute.

Inspection
1. Inspect no. 3 Intake air control valve assembly (A) inspect actuator operation. (1) With 26.7 Kpa (200 mm hg, 7.9 In. Hg) of vacuum applied to the actuator, check that the actuator rod m ...

Vacuum switching valve
Components REMOVAL 1. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (a) Remove the 2 vacuum hoses and vacuum switching valve connector. (b) Remove the screw and vacuum switching valve. ...

Other materials:

Clearance warning ECU
COMPONENTS REMOVAL 1. REMOVE FRONT DOOR SCUFF PLATE LH 2. REMOVE COWL SIDE TRIM BOARD LH 3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH 4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY 5. REMOVE CLEARANCE WARNING ECU  Disconnect each connector. &nb ...

Wrong Disc/ Disc cannot be Read
DTC 63-41 Wrong Disc DTC 63-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detection Condition Trouble Area 63-41 An unsuitable disc is inserted CD  Radio and navigation assembly 63-42 The disc cannot be read INSP ...

Mute Signal Circuit between Radio and Navigation Assembly and Television Display Assembly
DESCRIPTION The radio and navigation assembly controls the volume according to the MUTE signal from the television display assembly. The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode, etc. If there is an open in the circuit, noise can be heard ...

В© 2011-2024 Copyright www.tsienna.net