Toyota Sienna Service Manual: Valve body assembly

Installation

1. INSTALL TRANSMISSION WIRE (a) Coat the O-ring of the transmission wire connector with ATF and install it. (b) Install the transmission wire with the bolt. Torque: 5.4 N*m (55 kgf*cm, 48 ...

Removal

1. Remove engine under cover no.1 2. Disconnect cable from negative battery terminal 3. Drain automatic transaxle fluid (see page ax-131) 4. Remove automatic transaxle oil pan subassembly (a ...

Other materials:

Lumbar support adjuster assembly
INSPECTION 1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY  Check operation of the lumbar support adjuster motor.  Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminal. OK If the r ...

Disassembly
1. REMOVE RADIATOR WATER INLET (a) Remove the 2 bolts and radiator water inlet. 2. REMOVE DRAIN PLUG (a) Remove the drain plug and air drain plug. (b) Remove the 2 O-rings. 3. REMOVE LOWER RADIATOR TANK (a) Install the claw to the overhaul handle, inserting it in the hole in Part A ...

Short in Side Squib LH Circuit
DTC B0115/47 Short in Side Squib LH Circuit DESCRIPTION The side squib LH circuit consists of the center airbag sensor assembly and the front seat side airbag assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0115/47 is recorded when a short ci ...