Toyota RAV4 manuals

Toyota Sienna Service Manual: Vanity light

ON-VEHICLE INSPECTION

1. LH VISOR ASSEMBLY

  1.  Inspect vanity light resistance.
  1.  check that the resistance exists between the terminal 1 and the terminal 2 when the light is operated.

Resistance:
OFF (closed): 10 kΩ or higher
ON (opened): Below 1 Ω

2. RH VISOR ASSEMBLY

  1.  Inspect vanity light resistance.
  1.  check that the resistance exists between the terminal 1 and the terminal 2 when the light is operated.

Resistance:
OFF (closed): 10 kΩ or higher
ON (opened): Below 1 Ω

Ignition key cylinder light
ON-VEHICLE INSPECTION 1. KEY CYLINDER LIGHT ASSEMBLY  Connect the battery positive (+) lead to the terminal 1 and the battery negative (-) lead to the terminal 2, and check that the ...

Headlight dimmer switch
COMPONENTS REMOVAL 1. REMOVE STEERING COLUMN LOWER COVER 2. REMOVE STEERING COLUMN UPPER COVER 3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY  Disconnect the connector.  Releas ...

Other materials:

Rear Occupant Classification Sensor RH Collision Detection
DTC B1788 Rear Occupant Classification Sensor RH Collision Detection DESCRIPTION DTC B1788 is output when the occupant classification ECU receives a collision detection signal sent by the rear occupant classification sensor RH if an accident occurs. DTC B1788 is also output when the front s ...

Removal
1. REMOVE REAR DOOR SCUFF PLATE LH 2. REMOVE REAR DOOR WEATHERSTRIP LH 3. REMOVE BACK DOOR WEATHERSTRIP 4. REMOVE BACK DOOR SCUFF PLATE 5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH 6. REMOVE VOLTAGE INVERTER ASSEMBLY  Disconnect the connector.  Remove the 2 bolts and the v ...

Anti-glare function
Manual anti-glare inside rear view mirror Reflected light from the headlights of vehicles behind can be reduced by operating the lever. Normal position Anti-glare position Auto anti-glare inside rear view mirror Responding to the level of brightness of the headlights of veh ...

В© 2011-2024 Copyright www.tsienna.net