DTC P0500 Vehicle Speed Sensor Malfunction
DTC P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High
DESCRIPTION The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system.
If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system. The speed signal is converted for use by the cruise control inside the ECM.
Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.
DTC No. |
DTC Detection Condition |
Trouble Area |
P0500 |
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while cruise control is in operation |
|
P0503 |
Momentary interruption and noise are detected when a rapid change of vehicle speed occurs while cruise control is in operation |
|
WIRING DIAGRAM
Refer to DTC P0500
INSPECTION PROCEDURE
Refer to DTC P0500
Precaution
1. PRECAUTION
(a) Before inspecting and repairing the fuel system,
disconnect the cable from the negative (-) battery
terminal.
(b) Do not smoke or work near fire when handling the
fuel system.
(c) Keep gasoline away from rubber or leather parts.
2. DISCHARGE FUEL SYSTEM PRESSURE (*1)
...
Slide door lock
INSPECTION
1. INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSEMBLY LH
Inspect the resistance of the switch.
Resistance
If the result is not as specified, replace the control
assembly.
2. INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSEMBLY RH
Inspect the resistance of the swit ...
Short to GND in Front Pretensioner Squib RH
Circuit
DTC B0132/61 Short to GND in Front Pretensioner Squib RH
Circuit
DESCRIPTION
The front pretensioner squib RH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B ...