Toyota Sienna Service Manual: Voice Guidance does not Function
INSPECTION PROCEDURE
1 CHECK NAVIGATION SYSTEM SETTING
- Enter the "Menu" screen by pressing the "MENU" switch.
- Select "Volume".
- Check that "OFF" is not selected.
OK: "OFF" is not selected
2 CHECK NAVIGATION SETTING
- Enter the "Menu" screen by pressing the "MENU" switch.
- Select "Set up".
- Check that "Voice Guidance in All Modes" is not OFF.
OK: Voice guidance in all modes is not OFF.
3 CHECK NAVIGATION SETTING
- Enter the "Menu" screen by pressing the "MENU" switch.
- Select "Setup".
- Check that "Auto Voice Guidance" is not OFF.
OK: Auto voice guidance is not OFF
4 CHECK MAP DISC
- Check that the map disc is not deformed or cracked.
OK: No deformations or cracks on map disc.
5 CHECK RADIO AND NAVIGATION ASSEMBLY
- Check that audio sound can be heard from the driver side speaker.
OK: Audio sound can be heard
REPLACE RADIO AND NAVIGATION ASSEMBLY
GPS Mark is not Displayed
INSPECTION PROCEDURE
1 CHECK CABIN
Check the cabin for any object that might interrupt radio
reception on the instrument panel. If such an object
exists, remove it and check if the GPS mark r ...
Map Display Incomplete
INSPECTION PROCEDURE
1 CHECK MAP DISC
Check that the map disc is not deformed or cracked.
OK:
No deformations or cracks on map disc.
2 CHECK DISPLAY
Check that displays other than th ...
Other materials:
Coolant
Replacement
1. REMOVE NO. 1 ENGINE UNDER COVER (See page
EM-26)
2. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-28)
3. DRAIN ENGINE COOLANT
(a) Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it
according to the regulations in your area.
(b ...
Other functions
Switching between outside air and recirculated air modes
Press .
The mode switches between outside air mode (
appears on the
display) and recirculated air mode (
appears on the display) each
time the button is pressed.
Defogging the windshield
Defoggers are used to defog the windshield a ...
Installation
1. INSTALL REAR AXLE BEAM DAMPER
(a) Install the rear axle beam damper to the rear axle
beam assembly.
2. INSTALL REAR AXLE CARRIER BUSH LH
(a) Align the matchmarks on the axle beam assembly
with the 2 notches of a new bushing and temporarily
install the bushing to the rear axle beam assem ...
