INSPECTION PROCEDURE
1 CHECK NAVIGATION SETTINGS
OK: Voice Recognition Guidance is not OFF.
2 CHECK MAP DISC
OK: No deformations or cracks on map disc.
3 CHECK MAP DISC
OK: No dirt is on the map disc surface.
NOTICE: Do not use a conventional record cleaner or antistatic preservative.
HINT: If the disc is dirty, clean the disc by wiping the disc's surface radially with a soft cloth.
4 CHECK MICROPHONE (NAVIGATION CHECK MODE)
HINT: Voice can be recorded up to 5 seconds.
OK: All check results are normal.
REPLACE RADIO AND NAVIGATION ASSEMBLY
ECU Power Source Circuit
DESCRIPTION
This is the power source for the tire pressure warning ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the tire pressure warning ECU, read the transmitter IDs
stored in the old ECU
using the intelligent tester and write them down before removal.
It is neces ...
Installation
1. INSTALL RADIO NO. 2 BRACKET
Install radio No. 2 bracket with the 4 screws.
2. INSTALL RADIO NO. 1 BRACKET
Install radio No. 1 bracket with the 4 screws.
3. INSTALL RADIO RECEIVER
Connect the connector.
Install the radio receiver with the 4 scr ...
Engine Coolant Temperature / Intake Air Temperature
Correlation
DTC P011B Engine Coolant Temperature / Intake Air Temperature
Correlation
DESCRIPTION
The ECM calculates the difference between the readings of the coolant
temperature sensor and intake air
temperature sensor. If the difference is greater than 20C (68F), the ECM will
judge this as a malfunct ...