Toyota Sienna Service Manual: When towing full-time 4wd vehicles
- Use one of the methods shown below to tow the vehicle.
- If the vehicle has trouble with the chassis or drive train, use method 1 (flat bed truck).
WHEN TOWING FULL-TIME 4WD VEHICLES
- The towing methods shown below are dangerous and can damage the vehicle, so do not use them.
For vehicles equipped with vehicle stability control (vsc) system
(a) Notices when using drum tester
Notices when using drum tester.
(1) When using a drum tester, be sure to start the
engine with the ignition switch OFF, and connect
SST to the terminals TS ...
For vehicles equipped with catalytic converter
CAUTION: If a large amount of unburned gasoline or gasoline vapors flow
into the converter, it may cause overheating and create a fire hazard. To
prevent this, observe the following precautio ...
Other materials:
Manual headlight leveling dial (vehicles with discharge headlights)
The level of the headlight aim can be adjusted according to the number
of passengers and the loading condition of the vehicle.
Raises the level of the headlights
Lowers the level of the headlights
Guide to dial settings
Daytime running light system (if equipped)
Bulb type: To ...
Noise Occurs
INSPECTION PROCEDURE
1 NOISE CONDITION
Check in which direction the noise comes from (front left
or right, or rear left or right).
Check in which direction the noise comes from.
OK:
The location of the noise source can be
determined
2 CHECK SPEAKERS
Check the installation cond ...
Terminals of ECU
1. CHECK INSTRUMENT PANEL J/B ASSEMBLY
(MULTIPLEX NETWORK BODY ECU)
Disconnect the B6, B7 and B9 ECU connectors.
Disconnect the 1A, 1C, 1L and 1K J/B connectors.
Measure the voltage and resistance between each
terminal of the wire harness side connectors and
body gro ...
