Toyota Sienna Service Manual: Wiper and washer system
PRECAUTION
1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT
- Do not clean or adjust the washer nozzle with a safety pin, etc. because;
- the washer nozzle tip is made of resin and could be damaged.
- adjustment is not necessary because the washer nozzle is a spray type.
- In case the washer nozzle is clogged with wax etc., remove it and clean the nozzle hole with a soft resin brush, etc.
PROBLEM SYMPTOMS TABLE
1. FRONT WIPER AND WASHER SYSTEM
2. REAR WIPER AND WASHER SYSTEM
3. WASHER FLUID LEVEL WARNING SYSTEM
Wiper and washer
...
Front wiper motor
COMPONENTS
...
Other materials:
For vehicles equipped with vehicle stability control (vsc) system
(a) Notices when using drum tester
Notices when using drum tester.
(1) When using a drum tester, be sure to start the
engine with the ignition switch OFF, and connect
SST to the terminals TS and CG of the DLC3
before the measurement in order to cancel the
VSC operation.
SST 09843-18040
...
Reassembly
1. INSTALL INPUT SHAFT OIL SEAL RING
(a) Compress a new input shaft oil seal ring from both
sides to reduce dimension A.
Dimension A:
5 mm (0.197 in.)
(b) Coat the oil seal ring with ATF and install it to the
input shaft.
NOTICE:
Do not expand the end gap of the oil seal ring
too much. ...
Warning lights and
indicators
The warning lights and indicators on the instrument cluster and
center panel inform the driver of the status of the vehicle’s various
systems.
For the purpose of explanation, the following illustration displays
all warning lights and indicators illuminated.
Vehicles with monochrome displ ...
