Toyota Sienna Service Manual: Wiper switch
COMPONENTS
REMOVAL
1. REMOVE STEERING COLUMN COVER
2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
- Disconnect the connector.
- Using a screwdriver, disengage the claw and pull
out the windshield wiper switch assembly.
NOTICE:
The claw will be broken if pressed hard.
HINT:
Tape up the screwdriver tip before use.
INSPECTION
1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY
- Continuity Check
- Check the continuity between each of the
terminals of the connector.
Standard:
Front Wiper Switch
Front Washer Switch
Rear Wiper Switch
Rear Washer Switch
- Intermittent Operation Check
- Connect the voltmeter (+) terminal to the
terminal 7 (+1) of the connector, the voltmeter
(-) terminal to the terminal 2 (EW) of the
connector.
- Connect the battery (+) to the terminal 17 (+B)
of the connector, the battery (-) to the terminal 2
(EW) and the terminal 16 (+S) of the connector.
- Turn the wiper switch into the INT position.
- Connect the battery (+) to the terminal 16 (+S)
of the connector for 5 seconds.
- Connect the battery (-) to the terminal 16 (+S)
of the connector. Operate the intermittent wiper
relay and check voltage between the terminal 7
(+1) and the terminal 2 (EW).
- Operation Check (Front Wiper)
- Turn the wiper switch into the OFF position.
- Connect the battery (+) to the terminal 17 (+B)
of the connector, the battery (-) to the terminal
16 (+S) and 2 (EW) of the connector.
- Connect the voltmeter (+) terminal to the
terminal 7 (+1) of the connector, the voltmeter
(-) terminal to the terminal 2 (EW) of the
connector. Turn the washer switch ON and
OFF and check voltage between the terminal 7
(+1) and the terminal 2 (EW).
INSTALLATION
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
2. REMOVE STEERING COLUMN COVER
COMPONENTS
REMOVAL
1. REMOVE REAR WIPER BLADE ASSEMBLY
Remove the rear wiper arm head cap from the rear
wiper arm.
Raise the rear wiper blade to the position as shown
i ...
ON-VEHICLE INSPECTION
1. INSPECT FRONT WASHER MOTOR
Operation Check
Pour the water into the washer jar with the
windshield washer motor and pump installed to
the washer ...
Other materials:
Short in Driver Side Squib Circuit
DTC B0100/13 Short in Driver Side Squib Circuit
DESCRIPTION
The driver side squib circuit consists of the center airbag sensor assembly,
the spiral cable and the
steering pad. The circuit instructs the SRS to deploy when deployment conditions
are met. DTC B0100/13
is recorded when a short ci ...
Front Clearance Sonar Sensor LH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the received
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PROC ...
System description
1. BRIEF DESCRIPTION
The CAN (Controller Area Network) is a serial data
communication system for real time application. It is
a vehicle multiplex communication system which
has a high communication speed (500 kbps) and
the ability to detect malfunctions.
By pairing the CANH and CANL bu ...