Toyota Sienna Service Manual: Wireless Door Lock Tuner Circuit Malfunction
DTC B1242 Wireless Door Lock Tuner Circuit Malfunction
DESCRIPTION
When a RDA signal is not input to the door control receiver within 1 second after the multiplex network body ECU outputs a PRG signal, this DTC is set.
|
DTC No. |
DTC Detection Condition |
Suspected Area |
|
B1242 |
Within 1 second after PRG signal is output from multiplex network body ECU during self-diagnostic mode, corresponding RDA signal is not input |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - MULTIPLEX NETWORK BODY ECU)
- Disconnect the D4 receiver connector.
- Disconnect the B9 ECU connector.
- Check the resistance between the wire harness side connectors.
Standard resistance
- Check the voltage and resistance between the D4 receiver connector or B9 ECU connector and the body ground.
Standard
2 CHECK DOOR CONTROL RECEIVER
- Check that the DTC is not output.
REPLACE MULTIPLEX NETWORK BODY ECU
Diagnostic trouble code chart
HINT:
If a trouble code is displayed during the DTC check,
inspect the circuit listed for that code. For details of the
code, refer to the "See page" in the DTC chart.
...
No Answer-Back (Hazard Warning Light and Wireless Door Lock
Buzzer)
DESCRIPTION
If there is no answer-back of the hazard light signal and the wireless door lock
buzzer although the
wireless control function is operating normally, there might be a malfunction in
...
Other materials:
Installation
1. INSTALL RADIO NO. 2 BRACKET
Install radio No. 2 bracket with the 4 screws.
2. INSTALL RADIO NO. 1 BRACKET
Install radio No. 1 bracket with the 4 screws.
3. INSTALL RADIO RECEIVER
Connect the connector.
Install the radio receiver with the 4 scr ...
No. 1 Clearance Warning Buzzer Circuit
DESCRIPTION
The clearance warning ECU receives the ultrasonic sensor signal to sound the
front warning buzzer.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FRONT BUZZER
Remove the clearance warning ECU with front buzzer.
Apply the battery voltage to the terminals 1 and 2 o ...
System description
1. OUTLINE OF THEFT DETERRENT SYSTEM
When the theft deterrent system detects that the
vehicle is being tampered with, the system sets off
the alarm, causing the horns to sound and the lights
to light up or blink in order to alert people around the
vehicle to the theft.
The ...
