Toyota Sienna Service Manual: Yaw Rate Sensor Communication Stop Mode

Toyota Sienna Service Manual / Can communication / Can communication system / Fail-safe chart / Yaw Rate Sensor Communication Stop Mode

DESCRIPTION

Detection Item	Symptom	Trouble Area
Yaw Rate Sensor Communication Stop Mode	"Yaw rate/ Deceleration sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Yaw Rate Sensor Communication Stop Mode" in the "DTC COMBINATION TABLE"	Power source circuit of yaw rate sensor Yaw rate sensor branch wire or connector Yaw rate Sensor

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT: Operating the ignition switch, any switches, or any doors triggers related ECU and sensor communication with the CAN. This communication will cause the resistance value to change.

1 CHECK OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE)

CHECK OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE)

Turn the ignition switch off.
Disconnect the yaw rate sensor connector.
Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

2 CHECK WIRE HARNESS (IG, GND)

CHECK WIRE HARNESS (IG, GND)

Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

REPLACE YAW RATE SENSOR

Steering Angle Sensor Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Steering Angle Sensor Communication Stop Mode "Steering angle sensor" is not displayed on ...

ECM Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area ECM Communication Stop Mode "Engine" is not displayed on the "Communication Bus Che ...

Other materials:

High Temperature
DTC 44-47 High Temperature DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-47 Sensor detects that DVD unit temperature is high (Over 80C). Television display assembly INSPECTION PROCEDURE HINT: After the inspection is completed, cl ...

Rear Blower Motor Circuit
DESCRIPTION Power to the rear blower motor is supplied from the battery via the RR A/C relay. The rear blower motor speed level varies between 0 and 31 based on the voltage difference measured between the terminals of the motor. The voltage difference measured between the terminals of th ...

On-vehicle inspection
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. With the front passenger airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrumen ...