Toyota RAV4 manuals

Toyota Sienna 2010-2021 Owners Manual: Adjusting the height of rear view mirror

Toyota Sienna. Adjusting the height of rear view mirror


The height of the rear view mirror can be adjusted to suit your driving posture.

Adjust the height of the rear view mirror by moving it up and down.

Inside rear view mirror
The rear view mirror’s position can be adjusted to enable sufficient confirmation of the rear view. ...

Anti-glare function
Manual anti-glare inside rear view mirror Reflected light from the headlights of vehicles behind can be reduced by operating the lever. Normal position Anti-glare position Auto ...

Other materials:

Readiness monitor drive pattern
1. PURPOSE OF READINESS TESTS  The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emissionrelated components, and indicate any detected abnormalities with DTCs (Diagnostic Trouble Codes). Since various components need to be monitored in different d ...

Display Signal Circuit between Radio and Navigation Assembly and Television Camera Assembly
DESCRIPTION This is the display signal circuit of the television camera assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION CAMERA ASSEMBLY) Disconnect the R10 connector from the radio and navigation assembly. &nbs ...

Repair
1. INTRODUCTION (a) This section introduces ways to determine whether the run-flat tire is repairable or not. Repair must be performed by following the appropriate procedures. If a flat tire occurs, it is possible to drive a maximum of 160 km (100 miles) at a speed below 90 km/h (55 mph) due ...

© 2011-2021 Copyright www.tsienna.net