Toyota RAV4 manuals

Toyota Sienna 2010-2020 Owners Manual: Bluetooth® phone message function

Toyota Sienna 2010-2020 Owners Manual / Audio system / Bluetooth® phone / Bluetooth® phone message function

Received messages can be forwarded from the connected Bluetooth® phone, enabling checking and replying using the audio system.

Depending on the type of Bluetooth® phone connected, received messages may not be transferred to the message inbox.

If the phone does not support the message function, this function cannot be used.

Displaying message inbox screen

  1. Press button.

  2. Select .

Speaking on the phone
The following screen is displayed when speaking on the phone. To adjust the call volume Select “-” or “+”. You can also adjust the volume using the steering switches or the volume knob. ...

Receiving a message
When an e-mail/SMS/MMS is received, the incoming message screen pops up with sound and is ready to be operated on the screen. Select to check the message. Select to refuse the message. Se ...

Other materials:

Sensor signal check by test mode (signal check) (when using sst check wire)
(a) When having replaced the skid control ECU and/or yaw rate and deceleration sensor, perform zero point calibration of the yaw rate and deceleration sensor. HINT: If the ignition switch is turned from the ON position to the ACC or off during test mode (signal check), DTCs of the signal ...

Disassembly
HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH Using a screwdriver, disengage the clip and claw, and remove the garnish. HINT: Tape the screwdriver tip before use. 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH ...

Door control transmitter
INSPECTION 1. INSPECT DOOR CONTROL TRANSMITTER  Inspect operation of the transmitter.  Remove the battery (lithium battery) from the transmitter.  Install a new or normal battery (lithium battery).  When a new or normal battery is not available, connect 2 new ...

© 2011-2020 Copyright www.tsienna.net