Toyota Sienna 2010-2026 Owners Manual: Auxiliary boxes
- Type A
Push the lid.
- Type B
Push down the knob.
- Type C (if equipped)
- Type D
- Type E (if equipped)
- Type F
Lift the lid.
- Type G (if equipped)
Removing the second center seat.
- Type H (if equipped)
- Type I (if equipped)
- Type J (if equipped)
- Type K (if equipped)
Coin holder (type B)
Nickels, quarters and dimes can be stored separately
| WARNING Maximum storage weight (type A) Do not store items heavier than 0.4 lb. (200 g). Doing so may cause the auxiliary box to open and the items inside may fall out, resulting in an accident. |
Door pockets
Front
Rear
NOTICE
Rear: Make sure magazines are not bent
or protruding from the sliding door pockets.
Do not insert anything too big so that
the shape of the s ...
Other materials:
System normal condition check
1. CHECK NORMAL CONDITION
If the symptom is applicable to any of the following,
it is intended behavior, and not a malfunction.
Symptom
Answer
A longer route than expected is chosen.
Depending on the road conditions, the radio and navigation assembly
m ...
Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT:
(See page EM-26)
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
HINT:
(See page DS-6)
3. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
HINT:
(See page DS-6)
4. REMOVE TRANSMISSION CONTROL CABLE CLAMP
(a) Remove the bolt and the transmission control cable
cla ...
Open in Driver Side Squib 2nd Step Circuit
DTC B1181/18 Open in Driver Side Squib 2nd Step Circuit
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor
assembly, the spiral cable and
the steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1181/18 is reco ...
