Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Rear ceiling lights

Turns the lights on/off

Toyota Sienna. Rear ceiling lights


When the personal/interior light main switch is in the off position, the rear ceiling lights will not turn on even if the switch is on.

Adjusting the rear personal/interior lights angle (if equipped)

Toyota Sienna. Adjusting the rear personal/interior lights angle


Push the edge of the light lens.

Illuminated entry system

To prevent battery discharge

If the interior lights remain on when the engine switch is turned off, the lights will go off automatically after 20 minutes.

Customization

Settings (e.g. the time elapsed before lights turn off) can be changed.

NOTICE

Rear ceiling lights (if equipped)

Do not hang anything on the gap between the ceiling light cover and the ceiling or pull the ceiling light cover strongly.

Doing so may cause damage.

Personal/interior lights
Front Turns the light on/off Rear Turns the light on/off When the personal/interior light main switch is in the off position, the rear personal lights will not turn on even if the switch is o ...

Using the storage features
...

Other materials:

Mass or Volume Air Flow Circuit
DESCRIPTION The Mass Air Flow (MAF) meter is a sensor that measures the amount of air flowing through the throttle valve. The ECM uses this information to determine the fuel injection time and to provide appropriate airfuel ratio. Inside the MAF meter, there is a heated platinum wire whic ...

Seat Position Airbag Sensor Circuit Malfunction
DTC B1153/25 Seat Position Airbag Sensor Circuit Malfunction DESCRIPTION The seat position airbag sensor circuit consists of the center airbag sensor assembly and the seat position airbag sensor. DTC B1153/25 is recorded when a malfunction is detected in the seat position airbag sensor cir ...

Meter Illumination does not Dim at Night
DESCRIPTION  Confirm that the vehicle is equipped with the optitron meter, then check this circuit.  The combination meter assembly receives a auto dimmer signal from the body ECU by the multiplex communication line. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK MULTIP ...

В© 2011-2026 Copyright www.tsienna.net