Toyota RAV4 manuals

Toyota Sienna 2010-2025 Owners Manual: Rear side sunshades

Toyota Sienna. Rear side sunshades


Toyota Sienna. Rear side sunshades


  1. Pull the tab up.
  2. Secure the sunshade using the hooks.

To retract the sunshade, pull the tab up slightly to unhook the sunshade, and lower the sunshade slowly.

NOTICE To ensure normal operation of the rear sunshades, observe the following precautions.
  • Do not place anything where it may hinder the opening/closing of the sunshade.
  • Do not place anything on the sunshade.
Assist grips
Type A An assist grip installed on the ceiling can be used to support your body while sitting on the seat. Type B An assist grip installed on the pillar can be used when gettin ...

Grocery bag hooks
The hooks are designed to hang things like a grocery bag. Type A (front seatback) (if equipped) Type B (third seatback) Type C (luggage compartment) Type D (luggage ...

Other materials:

How to proceed with troubleshooting
HINT:  Use this procedure to troubleshoot the engine immobiliser system.  The intelligent tester should be used in steps 4, 5 and 7. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 3 CRANK ENGINE FOR MORE THAN 10 SECONDS 4 CHECK FOR DTC C ...

Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1167/85 is ...

Rear Power Seat Switch Circuit
DESCRIPTION When the power rear no. 2 seat switch is operated, a recline signal is sent to the fold seat control ECU. The ECU activates the reclining motor based on the signal from the power rear no. 2 seat switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT FOLD SEAT CONTROL ECU ...

В© 2011-2025 Copyright www.tsienna.net