Toyota Sienna Service Manual: On-vehicle inspection

Toyota Sienna Service Manual / Supplemental restraint system / Side airbag sensor / On-vehicle inspection

1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

Perform a diagnostic system check.

2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

Perform a diagnostic system check.
When the center pillar of the vehicle or its area is damaged, check if there is any damage to the side airbag sensor. If there are any defects as mentioned below, replace the side airbag sensor with a new one:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling off of the label or damage to the serial number.

CAUTION: Be sure to follow the correct removal and installation procedures.

3. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)

Replace the side airbag sensor.

CAUTION: Be sure to follow the correct removal and installation procedures.

HINT: The side airbag sensor on the impacted side should be replaced after the front seat side airbag assembly and curtain shield airbag assembly have deployed.

Removal

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly be ...

Other materials:

AVC-LAN Circuit
DESCRIPTION Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication. When a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as the communication is discontin ...

Adjustment
CAUTION: Do not stare at the luminous portion of the laser during adjustment. The intensity of the laser light is low, but it may result in loss of sight. If operation is not carried out as specified, there may be a risk that you are exposed to hazardous radiation. HINT: ...

Customize parameters
1. Seat Belt Buzzer ON/OFF Setting The seat belt buzzer ON/OFF setting, which is a setting of the buzzer function of the combination meter, can disable the driver side seat belt buzzer and front passenger side seat belt buzzer. NOTICE: These buzzers should be on for safe driving. Perform ...