Toyota Sienna Service Manual: Accelerator pedal rod

Toyota Sienna Service Manual / Engine / 2Gr-fe engine control system / Sfi system / Accelerator pedal rod

COMPONENTS

Accelerator pedal rod

ON-VEHICLE INSPECTION

1. CHECK ACCELERATOR PEDAL ROD

CHECK ACCELERATOR PEDAL ROD

(a) Check the voltage.

(1) Connect the intelligent tester to the DLC3.

(2) Turn the ignition switch to the ON position.

(3) Turn the intelligent tester on.

(4) Select the menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / ACCEL POS #1, ACCEL POS #2.

(5) Operate the accelerator pedal, and then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specifications.

Standard voltage (ACCEL POS #1)

If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.

REMOVAL

1. REMOVE ACCELERATOR PEDAL ROD

REMOVE ACCELERATOR PEDAL ROD

(a) Disconnect the accelerator pedal position sensor connector.

(b) Remove the 2 nuts and accelerator pedal rod.

INSTALLATION

1. INSTALL ACCELERATOR PEDAL ROD

INSTALL ACCELERATOR PEDAL ROD

NOTICE:

Avoid physical shock to the accelerator pedal assembly.
Do not disassemble the accelerator pedal assembly.

(a) Install the accelerator pedal rod with the 2 nuts.

Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) (b) Connect the accelerator pedal position sensor connector.

ECM

COMPONENTS REMOVAL 1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (a) Push the right side wall and then push the left wall to release the stoppers. (b) Pull the glove compartment door sub-as ...

Mass air flow meter

COMPONENTS ON-VEHICLE INSPECTION 1. INSPECT MASS AIR FLOW METER NOTICE: Perform the mass air flow (MAF) meter inspection by following the procedures below. Only replace t ...

Other materials:

Identification information
VEHICLE IDENTIFICATION AND SERIAL NUMBERS 1. VEHICLE IDENTIFICATION NUMBER (a) The vehicle identification number is stamped on the vehicle identification number plate and the certification label, as shown in the illustration. A: Vehicle Identification Number Plate B: ...

Folding down the third seats (manual seats)
Before folding the third seats Fold the outside head restraints and lower the center head restraint to the lowest position , and stow the seat belt buckles. Stow the center seat belt. Folding down the third seatbacks Pull the “TO FOLD/LIFT SEATBACK” strap a Return ...

Fuel Pump Control Circuit
DESCRIPTION The FUEL PUMP relay switches the fuel pump speed according to the engine conditions. The fuel pump operates when the ECM receives the starter-operating signal (STA) and crankshaft-rotating signal (NE). The FUEL PUMP relay is turned ON while the engine is idling or operating at l ...