Toyota Sienna Service Manual: Removal
HINT: On the RH side, use the same procedures as on the LH side.
1. REMOVE SLIDE DOOR
- Remove the rear door scuff plate (See page IR-7).
- Remove the back door scuff plate (See page ED- 214).
- Remove the quarter trim panel (See page IR-9).
- Remove the upper rail cushion from the rail.
- Disconnect the 2 connectors from the body side and remove the bolt and wire.
- Open the quarter glass.
- Using a screwdriver, disengage the clip and 2 claws, remove the rail end moulding.
HINT: Tape the screwdriver tip before use.
- Remove the 2 bolts and bracket center No. 2 together with the tensioner (color: white).
- Remove the tensioner from the bracket center No.
2.
- Remove the 2 bolts and bracket center No. 1 together with the tensioner (color: black).
- Remove the tensioner from the bracket center No.
1.
- Remove the 2 nuts and open stop.
- Rotate the base of the slide door roller lower in the direction indicated by arrow in the illustration and then remove the roller from the cut area of the lower rail from the body side.
- Move the slide door rearward and then remove the slide door roller upper from the cut area in the rear part of the slide door rail upper.
- Move the slide door further rearward and then remove the slide door hinge center from the rear part of the slide door rail center. Then, remove the slide door.
2. REMOVE SLIDE DOOR RAILS
- Remove the roof headlining (See page IR-6).
- Remove the 2 bolts, 2 nuts and the rail upper.
- Remove the 2 screws and rear side rail.
- Remove the 3 screws and rail center
3. REMOVE SLIDE DOOR FULL OPEN STOP LOCK ASSEMBLY LH
- Disconnect the 2 cables.
- Remove the 2 bolts and full open stop lock.
4. REMOVE SLIDE DOOR ROLLER ASSEMBLY LOWER LH
- Remove the 3 bolts and roller.
5. REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH
- Remove the 3 bolts and hinge.
- LH side: Remove the cover.
6. REMOVE SLIDE DOOR ROLLER ASSEMBLY UPPER
- Remove the 2 bolts and roller.
Power slide door
COMPONENTS
...
Disassembly
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully o ...
Other materials:
Cellular Phone cannot Send / Receive
INSPECTION PROCEDURE
1 CHECK BLUETOOTH SETTINGS
Check if the Bluetooth settings are correct.
OK:
Bluetooth settings are correct.
2 CHECK CELLULAR PHONE
Check if the cellular phone is Bluetooth compatible.
HINT:
Some versions of Bluetooth compatible cellular phones
may not function ...
Rear Air Outlet Damper Position Sensor Circuit
DESCRIPTION
This sensor detects the position of the rear air outlet control servo motor
and sends the appropriate
signals to the A/C amplifier. The position sensor is built in the rear air
outlet control servo motor.
The position sensor's resistance changes as the rear air outlet contro ...
Accelerator pedal rod
COMPONENTS
ON-VEHICLE INSPECTION
1. CHECK ACCELERATOR PEDAL ROD
(a) Check the voltage.
(1) Connect the intelligent tester to the DLC3.
(2) Turn the ignition switch to the ON position.
(3) Turn the intelligent tester on.
(4) Select the menu items: DIAGNOSIS /
ENHANCED OBD II / D ...
