Toyota Sienna Service Manual: Transfer

U151f automatic transaxle

SST RECOMMENDED TOOLS EQUIPMENT LUBRICANT SSM ...

Propeller shaft

SST RECOMMENDED TOOLS EQUIPMENT ...

Other materials:

Installation
1. INSTALL CRANKSHAFT POSITION SENSOR  Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.  Install the crankshaft position sensor with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)  Connect the crankshaft position sensor connector. ...

Removal
1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER L ...

Diagnosis system
1. CHECK DLC3 (a) The vehicle's ECM uses the ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. HINT: Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and atte ...