Toyota Sienna Service Manual

Initialization

Items to initialize The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle. ...

Introduction

...

Other materials:

Absence of Registration Unit/ No Response for Connection Check/ Last Mode Error/ No Response Against ON / OFF Command/ Mode Status Error/ Slave Reset
DTC 01-D5 Absence of Registration Unit DTC 01-D8 No Response for Connection Check DTC 01-D9 Last Mode Error DTC 01-DA No Response Against ON / OFF Command DTC 01-DB Mode Status Error DTC 01-DE Slave Reset DESCRIPTION HINT:  *1: Even if no fault is present, this trouble code may b ...

Lumbar support adjuster assembly
INSPECTION 1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY  Check operation of the lumbar support adjuster motor.  Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminal. OK If the r ...

Camshaft Position "B" Actuator Circuit / Open
DTC P0013 Camshaft Position "B" Actuator Circuit / Open (Bank 1) DTC P0023 Camshaft Position "B" Actuator Circuit / Open (Bank 2) DESCRIPTION The Variable Valve Timing (VVT) system includes the ECM, OCV and VVT controller. The ECM sends a target duty-cycle control signal ...