Toyota Sienna 2010-2019 Owners Manual: General settings
Settings are available for adjusting the operation sounds, screen animation, etc.
Setup menu
You can adjust the audio system to your desired settings.
Display “Setup” screen
Press the “SETUP” button to display the “Setup” screen.
Select to adjust the settings for operati ...
Screen for general settings
Press the “SETUP” button.
Select “General” on the “Setup”
screen.
Select to adjust the clock.
“English”, “Français” or
“Español” can be ...
Other materials:
Diagnostic trouble code chart
HINT:
The parameters listed in the chart may not confirm exactly to
those read during the DTC check due to the type of
instrument or other factors.
If a trouble code is displayed during the DTC check in the
check mode, check the circuit for the code listed in the table
below. For details of ...
Installation
1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2
Sensor 1)
(a) Using SST, install the sensor to the exhaust
manifold LH.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use
with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use
without SST
HINT:
Use a torque wrench with a fulcrum ...
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for furthe ...