Toyota RAV4 manuals

Toyota Sienna 2010-2019 Owners Manual: The Blind Spot Monitor function

The Blind Spot Monitor function uses radar sensors to detect vehicles that are traveling in an adjacent lane in the area that is not reflected in the outside rear view mirror (the blind spot), and advises the driver of the vehicles existence via the outside rear view mirror indicator.

Summary of the Blind Spot Monitor
The Blind Spot Monitor is a system that has 2 functions: The Blind Spot Monitor function Assists the driver in making the decision when changing lanes The Rear Cross Traffic Alert function A ...

The Blind Spot Monitor function detection areas
The areas that vehicles can be detected in are outlined below. The range of the detection area extends to: Approximately 11.5 ft. (3.5 m) from the side of the vehicle The first 1.6 ft. ...

Other materials:

Installation
1. Install heated oxygen sensor (for bank 2 sensor 2) (see page ec-34) 2. Install front exhaust pipe assembly (a) Install 2 new gaskets to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 4 nuts. Torque: 62 n*m (632 kgf*cm, 46 ft.*Lbf) 3. INSTALL CE ...

Check mode procedure
HINT: Intelligent tester only: Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode. NOTICE:All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed fro ...

Installation
1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (a) Using a "TORX" socket wrench (E8), install the compressor and magnetic clutch with the 2 stud bolts. Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf) HINT: Tighten the stud bolts in the order shown in the illustration. (b) Install the c ...

В© 2011-2019 Copyright www.tsienna.net