Toyota RAV4 manuals

Toyota Sienna 2010-2018 Owners Manual: Vehicle interior

Items

Check points

Accelerator pedal
  • The accelerator pedal should move smoothly (without uneven pedal effort or catching).
Automatic transaxle “Park” mechanism
  • When parked on a slope with the shift lever in P, is the vehicle securely stopped?
Brake pedal
  • Does the brake pedal move smoothly?
  • Does the brake pedal have appropriate clearance from the floor?
  • Does the brake pedal have the correct amount of free play?
Brakes
  • The vehicle should not pull to one side when the brakes are applied.
  • The brakes should work effectively.
  • The brake pedal should not feel spongy.
  • The brake pedal should not get too close to the floor when the brakes are applied.
Head restraints
  • Do the head restraints move smoothly and lock securely?
Indicators/buzzers
  • Do the indicators and buzzers function properly?
Lights
  • Do all the lights come on?
  • Are the headlights aimed correctly?
Parking brake
  • Does the parking brake lever or pedal move smoothly?
  • When parked on a slope with the parking brake on, is the vehicle securely stopped?
Seat belts
  • Do the seat belts operate smoothly?
  • The seat belts should not be damaged.
Seats
  • Do the seat controls operate properly?
Steering wheel
  • Does the steering wheel rotate smoothly?
  • Does the steering wheel have the correct amount of free play?
  • There should not be any strange sounds coming from the steering wheel.
Engine compartment
Items Check points Battery Check connections Brake fluid Is the brake fluid at the correct level? Engine coolant Is the engine coolant at the corr ...

Vehicle exterior
Items Check points Doors Do the doors operate smoothly? Engine hood Does the engine hood lock system work properly? ...

Other materials:

How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS 3 CHECK INITIAL CHECK FUNCTION 4 PROBLEM SYMPTOMS TABLE THE CORRESPONDING SYSTEM DOES NOT EXIST (Go to step 5) 5 BASED ON THE MALFUNCTION SYMPTOM, PERFORM THE TROUBLESHOOTING BELOW Operation check (C).  Terminals of ECU 6 ...

Removal
1. Disconnect battery negative terminal 2. Remove instrument cluster finish panel sub-assembly center Hint: (see page ip-9) 3. Remove transmission control cable assembly (a) Remove the nut from the control shaft lever. (b) Disconnect the transmission control cable assembly from the con ...

Entire Combination Meter does not Operate
DESCRIPTION This is the power source circuit to operate the combination meter assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT COMBINATION METER ASSEMBLY Disconnect the C10 connector. Measure the resistance according to the value(s) in the table below. Standard resistan ...

© 2011-2018 Copyright www.tsienna.net