Toyota RAV4 manuals

Toyota Sienna 2010-2019 Owners Manual: Maintenance and care

Safety information for Safety Connect
Important! Read this information before using Safety Connect. Exposure to radio frequency signals The Safety Connect system installed in your vehicle is a low-power radio transmitter and receiver. ...

Maintenance and care
...

Other materials:

Catalyst monitor (active air-fuel ratio control type)
(a) Preconditions The monitor will not run unless: The MIL is OFF. (b) Drive Pattern (1) Connect an intelligent tester. (2) Turn the ignition switch to the ON position. (3) Turn the tester or scan tool ON. (4) Clear the DTCs. (5) Start the engine and warm it up. (6) Drive ...

How to proceed with troubleshooting
HINT: *: Use the intelligent tester. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS (a) Confirm problem symptoms 3 CHECK MULTIPLEX COMMUNICATION SYSTEM* Check if the multiplex communication system DTC is output. HINT: The center airbag sensor assembly of this system ...

Cold Start Ignition Timing Performance
DESCRIPTION This monitor will run when the engine is started at -10 to 50°C (14 to 122°F) of the engine coolant temperature. The DTC will set after the engine idling for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the ...

© 2011-2019 Copyright www.tsienna.net