Toyota Sienna 2010-2026 Owners Manual: Changing the rear setting
Adjusting the temperature setting
- Press the “REAR” button (indicator and rear temperature on the display on).
- Turn the “REAR TEMP” dial clockwise to increase the temperature
and counterclockwise to decrease the temperature.
The air conditioning system switches between individual (the lower side indicator on the “SYNC” button is off) and simultaneous (the lower side indicator on the “SYNC” button is on) modes each time the “SYNC” button is pressed.
Adjusting the fan speed
Press “
” on
to increase the fan speed and “
”
to
decrease the fan speed.
Press
to turn the fan off.
Changing the air outlets
Press the “REAR MODE” button.
The air outlets switch each time the button is pressed. (
Using the automatic mode
Press the “AUTO” button (“AUTO” appears on the display).
Adjust the temperature setting.
To stop the operation, press .
Automatic mode indicator
If the fan speed setting or air flow ...
Other functions
Switching between outside air and recirculated air modes
Press .
The mode switches between outside air mode (
appears on the
display) and recirculated air mode (
appears on the display) each
...
Other materials:
Automatic door locking and unlocking systems
The following functions can be set or cancelled: For instructions on
customizing, refer to
Function
Operation
Shift position linked door
locking function
Shifting the shift lever out of P locks all the
doors
Shift position linked door
unlocking function
...
Removal
1. REMOVE FRONT WHEEL
2. REMOVE REAR WHEEL
3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) Remove the valve core and cap, and release the air
from the tire.
(b) After ensuring that a sufficient amount of air has
been released, remove the nut and washer that are
used to secure ...
Rear Room Temperature Sensor Circuit
DESCRIPTION
This sensor detects the rear cabin temperature that is used as the basis for
temperature control and
sends a signal to the A/C amplifier.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 READ VALUE OF INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ign ...
