Toyota Sienna Service Manual: Drive shaft

Propeller shaft

SST RECOMMENDED TOOLS EQUIPMENT ...

Differential

SST RECOMMENDED TOOLS EQUIPMENT LUBRICANT SSM ...

Other materials:

Terminals of ECU
1. CLEARANCE WARNING ECU *1: with Front Clearance Sonar 2. AIR CONDITIONER AMPLIFIER ASSEMBLY *1: with Front Clearance Sonar *2: Manual A/C *3: Auto A/C  Reference: waveform 1 HINT:  Terminal: CBZ - E, BBZ - E, Z- - Body ground  Gauge set: 2 ...

Installation
1. Install heated oxygen sensor (for bank 2 sensor 2) (see page ec-34) 2. Install front exhaust pipe assembly (a) Install 2 new gaskets to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 4 nuts. Torque: 62 n*m (632 kgf*cm, 46 ft.*Lbf) 3. INSTALL CE ...

Installation
1. INSTALL OUTSIDE MOULDING Using a heat light, heat the mounting surface of the vehicle body between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the body excessively. Remove the tape from the vehicle body. Wipe off the stains with cleaner. Clean the outside moulding (if reusing t ...