Toyota Sienna 2010-2026 Owners Manual: Editing the contact data
For PBAP compatible Bluetooth® phones, this function is available when “Automatic Transfer” is set to off.
- Select “Edit Contact”.
- Select the desired contact.
- Select
corresponding to the
desired name or number.
- For editing the name
- Follow the steps in “Registering a new contact to the contacts list” from step 2.
- For editing the number
- Follow the steps in “Registering a new contact to the contacts list” from step 3.
Editing the contacts in a different way (From the “Contact Details” screen)
- Display the phone screen.
- Select the “Contacts”, “Call History” tab or the “Favorites” tab and select the desired contact.
- Select “Edit Contact”.
“E-mail Addresses”: Select to display all registered e-mail addresses for the contact.
- Follow the steps in “Editing the contact data” from step 4.
Registering a new contact to the contact list
New contact data can be registered. Up to 4 numbers per person can be
registered. For PBAP compatible Bluetooth® phones, this function is available
when “Automatic Transfer” is set to off.
...
Deleting the contact data
For PBAP compatible Bluetooth® phones, this function is available when
“Automatic Transfer” is set to off.
Select “Delete Contacts”.
Select the desired contact and select “Delete ...
Other materials:
Problem symptoms table
Use the table below to find the cause of the problem. The
numbers indicate the priority of the likely cause of the
problem. Check each part in order. If necessary, replace
these parts.
Front A/C:
Rear A/C:
...
Gateway ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Gateway ECU
Communication Stop
Mode
"Gateway" is not displayed on the "Communication
Bus Check" screen of the intelligent tester
Applies to "Gateway ECU Communication ...
Installation
1. INSTALL SHIFT LEVER ASSEMBLY
(a) Install shift lever assembly to the vehicle with the 4
bolts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
NOTICE:
Into datum hole of shift lever into datum pin of
instrument lower.
(b) Connect the 2 connectors to the shift lever
assembly.
...
