Toyota Sienna Service Manual: Headlight relay

Back door courtesy switch

INSPECTION 1. BACK DOOR LOCK ASSEMBLY (WITH OUT POWER BACK DOOR)  Inspect back door courtesy light switch operation.  Check that there is resistance between the terminal 5 a ...

Daytime running light relay

ON-VEHICLE INSPECTION 1. RUNNING LIGHT RELAY  Inspect relay resistance. Resistance ...

Other materials:

Power Slide Door RH does not Operate When Using Inside / Outside Handle
DESCRIPTION  The inside / outside handles have the ability to control operation of the power slide door. Pulling either handle transmits a request signal to the power slide door ECU RH, which then commands the power slide door control motor and clutch to open / close the power sli ...

Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).  Install the rear seat 3 point type belt assembly with the bolt. Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) 2. INSTALL ...

Power Seat Motor Circuit
DESCRIPTION When the power seat control switch is operated, a command signal is sent to the position control ECU and switch assembly (power seat control switch and ECU). The front power seat switch then controls the appropriate seat motor as needed. This memory system does not use a seat po ...