Toyota Sienna Service Manual: Lighting
- Lighting system
- Precaution
- Parts location
- How to proceed with troubleshooting
- Operation check
- Problem symptoms table
- Terminals of ECU
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Headlight assembly
- Daytime running light resister
- Fog light assembly
- Rear combination light assembly
- Back-up light assembly
- License plate light assembly
- High mounted stop light assembly
- Personal light assembly
- Room light assembly
- Door courtesy light (for Rear Side)
- Ignition key cylinder light
- Vanity light
- Headlight dimmer switch
- Turn signal light switch
- Hazard warning switch
- Headlight leveling switch
- Stop light switch
- Front door courtesy switch
- Rear door courtesy switch
- Back door courtesy switch
- Headlight relay
- Daytime running light relay
- Headlight dimmer relay
- Taillight relay
- Fog light relay
- Light control relay
- BRK relay
Adjustment
CAUTION:
Do not stare at the luminous portion of the laser
during adjustment. The intensity of the laser light is
low, but it may result in loss of sight.
If operation is not car ...
Lighting system
...
Other materials:
Folding and extending the mirrors
Manual type
Push the mirror back in the direction
of the vehicle’s rear.
Power type
Press the switch.
Folding
Extending
...
Reassembly
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad to the brake pedal subassembly.
2. INSTALL PUSH ROD PIN
(a) Apply lithium soap base glycol grease to inside
surface of 2 new push rod bushes.
(b) Install the 2 new push rod bushes.
(c) Install the 2 push rod pins with the 2 plate t ...
Sensor signal check by test mode (signal check) (when using sst check wire)
(a) When having replaced the skid control ECU and/or
yaw rate and deceleration sensor, perform zero
point calibration of the yaw rate and deceleration
sensor.
HINT:
If the ignition switch is turned from the ON
position to the ACC or off during test mode
(signal check), DTCs of the signal ...
