Toyota Sienna 2010-2026 Owners Manual: Replying to a message
- Display the message inbox screen.
- Select the desired message from the list.
- Select “Quick Message”.
- Select the desired message.
- Select “Send”.
If an error message is displayed, follow the guidance on the screen to try again.
Editing quick reply message
- Select “Quick Message”.
- Select
corresponding to the
desired message to edit. - Select “OK” when editing is completed.
Checking the messages
Display the message inbox screen.
Select the desired message from the list.
Check that the message is displayed.
E-mails: Select “Mark
Unread” or “Mark Read” to
mark mail ...
Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender’s phone
number.
Display the message inbox screen.
Select the desired message.
Select .
Check that the “Call” screen is displayed ...
Other materials:
Microphone Circuit between Microphone and Radio and Navigation
Assembly
DESCRIPTION
This circuit sends a microphone signal from the microphone to the radio and
navigation assembly.
It also supplies power from the radio and navigation assembly to the microphone.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RADIO AND NAVIGATION ASSEMBLY
Measure the v ...
Differential oil
Adjustment
1. INSPECT DIFFERENTIAL OIL
(a) Stop the vehicle on the level place.
(b) Remove the differential filler plug and gasket.
(c) Check that the oil surface is within 5 mm (0.20 in.)
from the lowest position of the inner surface of the
differential filler plug opening.
NOTICE:
...
DRL Relay Circuit
DESCRIPTION
The Multiplex network body ECU controls the DRL No.2 relay
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
Connect the intelligent tester to DLC3.
Turn the ignition switch ON and push the intelligent
tester main switch ON.
Sel ...
