Toyota Sienna 2010-2026 Owners Manual: Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender’s phone number.
- Display the message inbox screen.
- Select the desired message.
- Select
. - Check that the “Call” screen is displayed.
Calling from a number within a message Calls can be made to a number identified in a message’s text area.
This operation cannot be performed while driving.
- Display the Message Inbox screen.
- Select the desired message.
- Select the text area.
- Select
corresponding to the
desired number. - Check that the “Call” screen is displayed.
Calling from the incoming message screen
Replying to a message
Display the message inbox screen.
Select the desired message from the list.
Select “Quick Message”.
Select the desired message.
Select “Send”.
If an error message is displayed, f ...
Using the steering
wheel switches
The steering wheel switches can be used to operate a connected
cellular phone.
Operating a telephone using the steering wheel switches
Volume switch
Increase/Decrease the volume
Pres ...
Other materials:
Dtc check / clear
1. DTC CHECK (NORMAL MODE)
NOTICE:
When the diagnostic system is switched from the
normal mode to the check mode, all the DTCs and
freeze frame data recorded in the normal mode will
be erased. So before switching modes, always check
the DTCs and freeze frame data, and note the ...
Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT:
(See page EM-34)
2. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR
(a) Remove the 3 nuts and transverse engine engine
mounting insulator.
3. REMOVE FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH
(a) Remove the 2 bolts on the front sid ...
Installation
1. INSTALL STARTER ASSEMBLY
(a) Install the starter with the 2 bolts.
Torque: 37 N*m (380 kgf*cm, 26 ft.*lbf) for bolt
(b) Connect the starter connector.
(c) Install the terminal nut and cover the nut with the
cap.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf) for nut
2. INSTALL NO. 1 ...
