Toyota RAV4 manuals

Toyota Sienna Service Manual: 2Gr-fe emission control

Toyota Sienna Service Manual / Introduction / 2Gr-fe emission control

SST

SST

RECOMMENDED TOOLS

RECOMMENDED TOOLS

EQUIPMENT

EQUIPMENT

SSM

SSM

2GR-FE INTAKE

EQUIPMENT

EQUIPMENT

PREPARATION 2GR-FE EXHAUST

EQUIPMENT

EQUIPMENT

Preparation 2gr-fe fuel
SST RECOMMENDED TOOLS EQUIPMENT ...

Preparation 2gr-fe cooling
SST RECOMMENDED TOOLS EQUIPMENT COOLANT Capacity Classification 11.3 liters (12.0 US qts, 10.0 Imp. qts) Use only "TOYOTA Super Long Life Coolant" or simila ...

Other materials:

Rear Speed Sensor RH Circuit
DESCRIPTION Refer to DTCs C0200/31, C0205/32, C1235/35, and C1236/36 (See page BC-17). DTCs C1273/73 to C1278/78 can be deleted when the speed sensor sends a vehicle speed signal or the Test Mode ends. DTCs C1273/73 to C1278/78 are output only in the Test Mode. HINT: DTC C0210/33 ...

Power back door drive unit
INSPECTION 1. INSPECT POWER BACK DOOR DRIVE UNIT Remove the unit. Apply battery voltage to the terminals and check the motor operation. Standard If the result is not as specified, replace the drive unit. Check the resistance of the clutch terminals. Resistance If th ...

Installation
1. INSTALL VVT SENSOR (for Bank 2 Exhaust Side)  Install the VVT sensor with the bolt. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)  Connect the VVT sensor connector. 2. INSTALL VVT SENSOR (for Bank 2 Intake Side)  Install the VVT sensor with the bolt. Torque: 10 N* ...

В© 2011-2022 Copyright www.tsienna.net