Toyota Sienna Service Manual: Abbreviations used in manual

Terms

...

Glossary of sae and Toyota terms

This glossary lists all SAE-J1930 terms and abbreviations used in this manual in compliance with SAE recommendations, as well as their TOYOTA equivalents. ...

Other materials:

Perform zero point calibration of yaw rate and deceleration sensor (when using sst check wire)
NOTICE: While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it in a stationary condition. (Do not turn the ignition switch to the ON position.) Be sure to do this on a level surface (with an inclination of less than 1 %). (a) Proc ...

DTC check / clear
1. CHECK DTC  Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the DLC3.  Turn the ignition switch on.  Turn the tester ON.  Enter the following menu items: DIAGNOSIS / OBD/ MOBD / IM ...

For rear air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT REAR AIR MIX CONTROL SERVO MOTOR (a) Inspect servo motor operation. (1) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the arm turns to "HOT" side smoothly. (2) Connect the po ...