Toyota RAV4 manuals

Toyota Sienna 2010-2023 Owners Manual: Customizing vehicle features

Changing using the audio system screen

  1. Press the “SETUP” button.
  2. Select “Vehicle” on the “Setup” screen.
  1. Press the “APPS” button.
  2. Select “Setup” on the “Apps” screen and select “Vehicle”.

Various setting can be changed. Refer to the list of settings that can be changed for details.

Changing using the multi-information display

  1. Press the “DISP” switch to display the “SETTINGS” screen while the vehicle is stopped, and then press and hold the “DISP” switch to display the customize mode screen.
  2. Press the “DISP” switch and select the item, and then press and hold the “DISP” switch.
  3. Press the “DISP” switch and select the desired setting, and then press and hold the “DISP” switch.

To exit the customize mode, press the “DISP” switch to select the “EXIT”, and then press and hold the “DISP” switch.

  1. Use the meter control switches to select while the vehicle is
    stopped, and then press the center button to display the customize mode screen.
  2. Select the desired item, and then press the center button.
  3. Select the desired setting, and then press the center button.

To go back to the previous screen or exit the customize mode, press .


Customization
Customizable features Your vehicle includes a variety of electronic features that can be personalized to your preferences. The settings of these features can be changed using the multi-information ...

Customizable features
Settings that can be changed using the audio system screen Settings that can be changed using the multi-information display Settings that can be changed by your Toyota dealer Definition of s ...

Other materials:

Installation
1. Install thermostat (a) Install a new gasket to the thermostat. (b) Install the thermostat with the jiggle valve facing up. Hint: the jiggle valve may be set within 10° on either side of the prescribed position. 2. INSTALL WATER INLET (a) Install the water inlet with the 2 nuts . ...

Back-up Power Source Circuit
DESCRIPTION This is the back-up power source for the A/C amplifier. Power is supplied even when the ignition switch is off and is used for diagnostic trouble code memory, etc. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT FUSE (ECU-B) (a) Remove the ECU-B fuse from the engine room juncti ...

Turning the high beam on/off manually
Switching to low beam Pull the lever to the original position. Switching to high beam Turn the light switch to the position. The Automatic High Beam can be operated when The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicl ...

© 2011-2023 Copyright www.tsienna.net