Toyota Sienna 2010-2025 Owners Manual: Vehicle specifications

If the vehicle becomes stuck

Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow: Stop the engine. Set the parking brake and shift the shift lever to P. Remove the mud, s ...

Specifications

...

Other materials:

Brake fluid
Bleeding HINT: If any work is performed on the brake system or if air in the brake lines is suspected, bleed the air out of the brake system. NOTICE: Wash the brake fluid off immediately if it adheres to any painted surfaces. 1. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT (See page SP-13 ...

Reassembly
1. INSTALL FRONT DOOR WIRE LH Install the wire with the 2 bolts. Torque: Reference 8.0 N*m (82 kgf*cm, 71 in.*lbf) NOTICE: In order to prevent water leakage, be sure that the lip of the rubber grommet does not turn up or is not deformed when installing the wire. Connect the wir ...

On-vehicle inspection
HINT: The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (See page ES-1). 1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM (a) Connect the inte ...